AQUACIATPOWER TM ILD Heat pump availableoptions Options Description Advantages ILD ST / HE Single high pressure water pump with variable speed drive, HP variable speed single- water filter, water flow electronic control, pressure sensors. Quick, easy installation (plug & play), significant reduction pump hydraulic module Multiple water flow control opos. or more details, refer to thein energy consumption for pump use (more than two-thirds), ● dedicated chapter (expansion tank not included. Option with tighter water flow control, improved system reliability built-in hydraulic safety components available). Dual high pressure water pump with variable speed drive, HP variable speed water filter, variable water flow control, pressure sensors. Quick, easy installation (plug & play), significant reduction dual-pump hydraulic Multiple water flow control options. For more details, refer to thein energy consumption for pump use (more than two-thirds), ● module dedicated chapter (expansion tank not included. Option with tighter water flow control, improved system reliability built-in hydraulic safety components available). Lon gateway Bi-directional communication board complying with Lon Talk Connects the unit by communication bus to a building protocol management system ● Bacnet over IP Bi-directional high-speed communication using BACnet protocol Easy and high-speed connection by Ethernet line to a BMS. over Ethernet network (IP) Allows access to multiple unit parameters ● Energy Management Control board with additional inputs/outputs. See Contacts Extended remote control capabilities (setpoint reset by Module available in option on control description. 0-20 mA input, ice storage end, demand limits, boiler on/off ● command...) Contact for refrigerant 0-10 V signal to report any refrigerant leakage in the unit directlyd Immediate customer notification of refrigerant losses to the leak detection on the controller (the leak detector itself must be supplie by theatmosphere, allowing timely corrective actions ● customer) Compliance with Russian EAC certification Compliance with Russian regulations reguationsl ● Power factor correction Capacitors for automatic regulation of power factor (cos phi) Reduction of the apparent electrical power, compliance with value to 0.95. minimum power factor limit set by utilities ● Coil defrost resistance Electric heaters under the coils and the condensate pans Prevents frost formation on the coils; compulsory in the heaters heating mode, if the outdoor is below 0°C ● 230V electrical plug 230V AC power supply source provided with plug socket and Permits connection of a laptop or an electrical device during transformer (180 VA, 0,8 Amps) unit commissioning or servicing ● Expansion tank 6 bar expansion tank integrated in the hydraulic module Easy and fast installation (plug & play), & protection of closed ● water systems from excessive pressure with pump Connection sleeve to be screwed onto the Desuperheater connections with screwed joints Easy to install. Allows unit connection to a screw connector ● desuperheater Desuperheater flexible Flexible connections on the desuperheater water side Easy to install. Limit transmission of vibrations on the water couplings network ● Water buffer tank module Integrates a water buffer tank module Avoid short cycle on compressors and ensure a stable water ● in the loop with pump Isolate the unit from the building, prevent the transmission of Anti-vibration mounts Elastomer anti-vibration mounts to be fitted underneath the unit vibrations and associated noise to the building. Must be used ● in conjunction with a flexible connection on the water side Flexible connection Easy to install. Limits the transmission of vibrations to the couplings for the Flexible connections for the water type heat exchanger water network ● exchanger Desuperheater flexible Flexible connections on the desuperheater water side Easy to install. Limit transmission of vibrations on the water couplings network ● Water filter on the Water filter Prevents fouling in the water network ● evaporator no pump Setpoint adjustable via a Connections enabling a 4-20 mA signal input Simplified energy management, enabling the setpoint to be 40-2 mA signal set by a 4-20 mA external signal ● ● ALL MODELS Refer to the selection tool to find out which options are not compatible. 442 442 CATALOGUE 2021