AQUACIATCALEO TM TD Heat pump availableoptions Options Description Avantages TD Corrosion protection, traditio- Fins made of pre-treated aluminium (polyurethane and epoxy) Improved corrosion resistance, recommended for nal coils moderate marine and urban environments ● Fans with 100 Pa maximum available pressure. Each fan equip- Ducted fan discharge, optimised temperature TD XtraFan ped with a connection flange & sleeves allowing the connection control, based on the operating conditions and 100 to 300 to the ducting system. system characteristics Low Noise Aesthetic and sound absorbing compressor enclosure Noise level reduction by 1 to 2 dB(A) ● Xtra Low Noise Acoustic compressor enclosure and low-speed fans Noise emission reduction at reduced fan speed TD 100 to 300 Soft Starter Electronic starter on each compressor Reduced start-up current ● Hydraulic module frost Electric heater on the hydraulic module hydraulic module frost protection at low outside protection temperatures down to -20°C ● Unit equipped with supplementary water outlet temperature Optimised operation of two units connected in Master/slave operation sensor kit to be field-installed allowing master/slave operation ofparallel operation with operating time equalisation ● two units connected in parallel LON gateway Two-directional communication board complying with Lon Talk Connects the unit by communication bus to a protocol building management system ● Two-directional high-speed communication using BACnet proto Easy and high-speed connection by Ethernet line Bacnet over IP col over Ethernet network (IP) - to a building management system. Allows access to ● multiple unit parameters Compliance with Russian EAC certification Compliance with Russian regulations regulations ● Condenser screw connection Condenser inlet/outlet screw connection sleeves Allows unit connection to a screw connector sleeves kit ● Monitoring solution which allows customers to track and monitor Real-time expert technical support to improve M2M supervision (accessory) their equipment remotely in real time equipment availability and reports at customer hand ● to monitor and optimize operating equipment. Isolate unit from the building, avoid transmission of Anti-vibration mounts Elastomer antivibratils mounts to be place under the unit vibration and associate noise to the buiding. Must (Material classified B2 fire class according to DIN 4102 ). be used in conjunction witha flexible connection on ● the water side Condenser flexible sleeves Flexibles connections on the condenser water side Easy to install. Limits the transmission of vibrations connection to the water network ● Set point adjustment by Connections enabling a 4-20 mA signal input Simplified energy management, enabling the 4-20mA signal setpoint to be set by a 4-20 mA external signal ● ● ALL MODELS Refer to the selection tool to find out which options are not compatible.The European Ecodesign directive takes into account the product’s environmental impact throughout its life cycle. It defines the mandatory energy efficiency requirements for water chillers and heat pumps. Products that do not meet the energy efficiency requirements set by the new directive will gradually be phased out of the market, forcing manufacturers to develop and offer more efficient products. Like the ESEER relating to water chillers, the new seasonal coefficient of performance (SCOP) resulting from this new European directive is used to evaluate the energy efficiency of heat pumps. Until now, only the COP has been used to measure energy efficiency in heating mode. The COP was exclusively calculated using a single measuring point, and only took into account operation at full load, which did not represent the efficiency of the heat pump over an entire heating season. The purpose of the SCOP is to characterise the seasonal efficiency of the heat pump by taking into account the efficiency at partial load and full load established for several outdoor temperatures. The SCOP is the ratio between the building’s annual heating demand and the annual electricity consumption of the heating system. It is measured in accordance with standard EN14825 based on an average reference climate that takes into account several reference temperatures between -10°C and +16°C CATALOGUE 2021 375 375