AQUACIATTMLD ILD Water chillers Heat pump teChniCalChaRaCteRistiCs- Coolingonly AQUACIATTM LD 150 180 200 240 260 300 360 390 450 520 600 Oil charge POE SZ160 (EMKARATE RL 32-3MAF). Circuit A l 5,8 7,2 7,2 7,2 7 7 10,8 10,5 10,5 7 7 Circuit B l - - - - - - - - - 7 7 Control system Connect Touch Control Minimum capacity % 50 50 50 50 50 50 33 33 33 25 25 Air heat exchanger All-aluminium micro-channel coil Fans - Standard unit Quantity 1 1 1 1 1 1 2 2 2 2 2 Maximum total air flow l/s 4111 4111 4111 4167 5500 5583 8056 8056 82221100011167 Maximum rotation speed r/s 12 12 12 12 16 16 12 12 12 16 16 Water heat exchanger Direct expansion, plate heat exchanger Water volume l 2,6 3 3,3 4 4,8 5,6 8,7 9,9 11,3 12,4 14,7 Max. water-sideoperating pressure without hydraulic module kPa 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 Hydraulic module (option) Single or dual pump (as selected) Pump, victaulic screen filter, relief valve, vent valves (water and air), pressure sensors Expansion vessel volume (option) l 12 12 12 12 12 12 35 35 35 35 35 Expansion vessel pressure(4) bar 1 1 1 1 1 1 1,5 1,5 1,5 1,5 1,5 Max. water-side operating pressure with hydraulic module kPa 400 400 400 400 400 400 400 400 400 400 400 Water buffer tank module (option) Single or dual pump (as selected) Pump, victaulic screen filter, relief valve, vent valves (water and air), pressure sensors Water volume l 250 250 250 250 250 250 250 250 250 250 250 Expansion vessel volume (option) l 18 18 18 18 18 18 35 35 35 35 35 Expansion vessel pressure(4) bar 1 1 1 1 1 1 1,5 1,5 1,5 1,5 1,5 Max. water-side operating pressure with hydraulic module kPa 400 400 400 400 400 400 400 400 400 400 400 Water connections with or without hydraulic module Victaulic Connections inch 2 2 2 2 2 2 2 2 2 2 2 External diameter mm 60,3 60,3 60,3 60,3 60,3 60,3 60,3 60,3 60,3 60,3 60,3 Casing paint Colour code RAL 7035 and RAL 7024 (4)Upon delivery, the standard preinflation of the vessels is not necessarily at the optimum value for the installation. In order to enable free variation of the water volume, adjust the inflation pressure to a pressure close to that corresponding to the static head of the installation. Fill the installation with water (bleeding out any air) at a pressure 10 to 20 kPa higher than that of the vessel. CATALOGUE 2021 363 363