AQUACIATTMLD ILD Water chillers Heat pump availableoptions Options Description Advantages AQUACIATTM LD (R32) Quick and easy installation (plug & play), LP VSD single- Variable-speed single pump. For more details, refersignificant reduction in pumping energy pump to the dedicated chapter (expansion tank not consumption level (more than two-thirds), ● included) precise water flow control, improved system reliability Evaporator hydraulic module equipped with a Quick and easy installation (plug & play), Dual low-pressure low-pressure variable-speed pump, drain valve, air significant reduction in pumping energy variable-speed ven and pressure sensors. For more details, refert consumption level (more than two-thirds), to e dedicated section (expansion tank notth ● pump included; option with built-in hydraulic safety precise water flow control, improved system comonents available)p reliability Dual low-pressure water pump, water filter, electronic LP single-pump water flow control, pressure sensors. For more details, Quick and easy installation (plug & play) hydraulic module refer to the dedicated chapter (expansion tank not ● included; option with built-in hydraulic safety components) LP dual-pump Two-directonal communication board complying withi Connects the unit by communication bus to abuilding management system hydraulic module Lon Talk protocol ● Two-directional high-speed communication using Easy and high-speed connection by Ethernet line to Lon gateway BACnet protocol over Ethernet network (IP) a BMS. Allows access to multiple unit parameters ● Bacnet over IP EAC certification Compliance with Russian regulations ● Compliance with Thermal insulation of the evaporator inlet/outlet Prevents condensation on the evaporator entering/ Russian regulations refrigerant lines, with flexible and UV-resistant insulation leaving refrigerant lines ● Coating applied using a conversion process which Insulation of the modifies the surface of the aluminium producing a Protect2 Improved corrosion resistance of the evaporator entering/ coating that is integral to the coil. Complete immersion MCHE coils by 2, recommended for use in leaving refrigerant in a bath to ensure 100% coverage. No heat transfer moderately corrosive environments ● lines variation, tested to withstand more than 4000 hours of salt spray as per ASTM B117 Flexible, durable polyepoxide coating applied using an electro coating process to give micro-channel coils an Protect4 Improved corrosion resistance of the Protect2 anti- anti-UV top layer. Minimal heat transfer variation, tested MCHE coils by 4, recommended for use in corrosive corrosion protection to withstand more than 6000 hours of constant neutral environments ● salt spray as per ASTM B117, improved impact resistance as per ASTM D2794 Flexible, durable polyepoxide coating applied using an electro coating process to give micro-channel coils an Protect4 Improved corrosion resistance of the Protect4 anti- anti-UV top layer. Minimal heat transfer variation, tested MCHE coils by 4, recommended for use in corrosive corrosion protection to withstand more than 6000 hours of constant neutral environments ● salt spray as per ASTM B117, improved impact resistance as per ASTM D2794 Evaporator screw connection sleeves Evaporator inlet/outlet screw connection sleeves Allows unit connection to a screw connector ● (kit) ● ALL MODELS (*)Standard equipment on ILD version Refer to the selection tool to find out which options are not compatible. 346 346 CATALOGUE 2021